|
[注意]深山红叶启动光盘(WinPE&PE Builder)讨论专帖(违令者必删)
红叶兄,我刚才查看了一下服务器配置,发现服务器的SCSI驱动为WINXP自带的adpu160m.sys,我修改了一下TXTSETUP.SIF文件,
在[SourceDisksFiles]项目下添加
adpu160m.sys =1,,,,,,4_,4,1,,,1,4
在[HardwareIdsDatabase]项目下添加
PCI\VEN_9005&DEV_00CF ="adpu160m"
PCI\VEN_9005&DEV_008F ="adpu160m"
PCI\VEN_9005&DEV_00C0 ="adpu160m"
PCI\VEN_9005&DEV_0080 ="adpu160m"
PCI\VEN_9005&DEV_0081 ="adpu160m"
PCI\VEN_9005&DEV_00C0&SUBSYS_F6209005 ="adpu160m"
PCI\VEN_9005&DEV_00C0&SUBSYS_F6200E11 ="adpu160m"
PCI\VEN_9005&DEV_0080&SUBSYS_E2A09005 ="adpu160m"
PCI\VEN_9005&DEV_0080&SUBSYS_E2A00E11 ="adpu160m"
PCI\VEN_9005&DEV_0080&SUBSYS_62A09005 ="adpu160m"
PCI\VEN_9005&DEV_0080&SUBSYS_E2209005 ="adpu160m"
PCI\VEN_9005&DEV_0081&SUBSYS_62A19005 ="adpu160m"
PCI\VEN_9005&DEV_0082&SUBSYS_02109005 ="adpu160m"
在[SCSI.Load]项目下添加
adpu160m=adpu160m.sys,4
在[SCSI]项目下添加
adpu160m="Adaptec AIC-789X/AHA-3960 Ultra160 PCI SCSI Card"
并把adpu160m.sys文件拷贝到PEXP\SYSTEM32\DRIVERS目录中,但是用光盘启动服务器时死机,但启动别的机器正常,请问是否我添加的有误,应如何修改? |
|