|
原帖由 lihuai617 于 2011-10-5 17:16 发表
用了楼上的办法,无法启动啊
还是没有搞定
run --mem /DOS/MAXDOS9.IMG PQ
启动不了
就这样的参数,还是要加一点东西
可以试试附件的RUN MAXDOS.IMG放在/BOOT/IMGS/下面 附加参数就是想启动的程序的对应的批处理的文件名
如\MAXDOS.IMG\soft\下面Diskgen.bat Hddreg.bat CHKDSK.BAT CMOS.BAT GH.BAT MHDD.BAT PQ.BAT SFDISK.BAT等
对应菜单分别为
command RUN MAXDOS.IMG Diskgen
command RUN MAXDOS.IMG Hddreg
command RUN MAXDOS.IMGCHKDSK
command RUN MAXDOS.IMG CMOS
command RUN MAXDOS.IMG GH
command RUN MAXDOS.IMG MHDD
command RUN MAXDOS.IMG PQ
command RUN MAXDOS.IMG SFDISK
注意对maxdos7中程序启动的支持不同 必须先加 --max-ext 参数 如启动MAXDOS 7 中的 DiskGenius 菜单
command RUN MAXDOS7.IMG --max-ext lh ctmouse \r diskgen
[ 本帖最后由 sratlf 于 2011-10-6 12:45 编辑 ] |
|